M40A3 Stock ,OD color.
This is made by Model Works (Taiwanese company)
For TM VSR-10,
[Recommend to use TM original chamber]
On front end, this stock has a square hole to put the HOP lever as original.
[Recommend to use G-SPEC Handle]
We found we can't use Pro Sniper's handle without any modification.
G-SPEC handle is OK,also PDI Surgeon handle is OK,too.
Using Pro sniper handle,please adjust by a file(to stock side)
[Note to use PDI upgrades together]
This design is for TM original VSR-10 so it's tight for PDI receiver or Outer barrel.
If you use them together,need to expand inside wall.
I paint in red
[Come with some screws]
This kit has three screws to assemble upper kit.
You don't need to buy PDI "Stock screw" & "Trigger guard screw"
Please note this products are good quality but not PDI's product.